JBswear Catalogue_web_2022

EN388 4 3 4 4 D Cut (TDM-100) A~F Puncture 1~4 Tear 1~4 Cut ( Coup Test) 1~5 Abrasion 1~4 Large quantities of molten metal Small splashes of molten metal Radiant heat Convective heat Contact heat Burning behaviour Resistance to convective cold (Performance level 0-4) Resistance to contact cold (Performance level 0-4) The higher performance level the better insulating capacity Permeability to water (Performance level 0 or 1) 0 = Water penetration after 30minutes 1 = No water penetration after 30 minutes Oil & Fuel Resistant Sole Anti-Static Slip Resistant Kick Off Lugs At Heel Nitrile/PU Sole Construction TPU/PU Sole Construction PVC/Nitrile Construction Upper&Sole PU/PU Sole Construction ShockAbsorbent Heel Flex Zone Technology SteelToeCap Composite ToeCap Removable Insockwith PORON® Insert Non-Marking Sole BumpCap Removable PU Insock ExtraThick Removable PU Insole Footwear Australian Standards AS/NZS:1906.4:2010 AS/NZS:4602.1:2011 Day & Night Hi Visibility – Day & Night The garment is highly visible in day- light and features reflective material for heightened night-time visibility. Australian Standards AS/NZS:1906.4:2010 AS/NZS:4602.1:2011 Day Only Hi Visibility – Day Only The garment is highly visible in the daylight. Australian Standards AS/NZS:4602.1:2011 Night Only Australian Standards AS/NZS:1906.4:2010 AS/NZS:4602.1:2011 Night Only Hi Visibility – Night The garment is highly visible in the Night. EN388:2016 Mechanical Risks Rating EN388 standard covers main areas of concern for mechanical hazards, and these areas are graded by a number, as per the table below: 1 is the lowest rating, and highest rating as below. EN12477:2001 (Protective gloves rating for welders) Type A refers to gloves with high protection against heat but with lower flexibility and dexterity; Type B refers to gloves with lower protection against heat but with greater flexibility and dexterity EN511 (Cold Protection) This standard applies to any gloves to protect the hands against convective and contact cold down to -50 degrees Celsius The pictogram will be accompanied by a 3-digit code. Benchmark Product Certification BSI Group ANZ Pty Ltd (BSI) has developed the BSI Benchmark Product Certification Criteria (Benchmark) for manufacturers and suppliers of product certification products supplied into the Australian market. The Benchmark Brand belongs to BSI and is an accredited JAS-ANZ product certification scheme. Anti Fog Treatment that prevents the condensation of water on lenses creating the illusion of fog. Recycled Products that are or can be recycled and made suitable for re-use. Polarised Polarized eyewear designed to reduce glare from surfaces such as water, snow, and glass. Category 2 - Intermediate Gloves of intermediate design, for intermediate risks. SAI Global Product Certification SAI Global Product Certification Services provides third party assurance that a particular product meets the specified requirements of a nominated product standard. SAI Global Standards-mark™ on the product represents reliability, quality assurance and safety. AS/NZS Standard Puncture resist mid sole Chemical Resistant Waterproof Water Repellent Upper HeatResistant 3 0 0 ° c LightWeight Composite ToeProtection LightWeight Airport Friendly EN407 4 4 4 4 4 4 EN511 X 2 X Test Rating 5 PRODUCT ICONOGRAPHY